Checking, Disassembling And Servicing; Disassembling And Assembling; Separating Rear Axle Case From Transmission Case - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM

4. CHECKING, DISASSEMBLING AND SERVICING

[1] DISASSEMBLING AND ASSEMBLING

(1) Separating Rear Axle Case from Transmission Case

Draining Transmission Fluid
• See page 2-S5.
Rear Wheel and Fenders
1. Place disassembling stand under the transmission case.
2. Remove the three point linkage (4).
3. Remove the rear wheel (3).
4. Disconnect the 6P connector for hazard and tail light.
5. Disconnect the jumper leads for PTO safety switch.
6. Remove the fenders (2).
7. Remove the seat (1).
(When reassembling)
IMPORTANT
• Be sure to assemble the seat switch 2P connector to the
harness connector with Red / Green and Orange / White
color wire. (If equipped OPC system.) (Refer to 9.
ELECTRICAL SYSTEM.)
Tightening torque Rear wheel mounting nut
(1) Seat
(2) Fender
ROPS and Brake Rod
1. Remove the ROPS under frame (R.H.) (1).
2. Remove the brake rod (R.H.) (2).
3. Remove the differential lock rod (if separating right side), (M6800
only).
4. Remove the DT shift rod (if separating left side).
5. Remove the fuel tank (if separating left side).
(When reassembling)
ROPS mounting screw
Tightening torque
M16-9T
(1) ROPS Under Frame (R.H.)
Rear Axle Case
1. Remove the rear axle case mounting screws and nuts.
2. Support the rear axle case with nylon lift strap and hoist.
3. Separate the rear axle case from transmission case.
(When reassembling)
• Apply liquid gasket (Three Bond 1216 or equivalent) to joint face
of the rear axle case and transmission case, after eliminate the
water, oil and stuck liquid gasket.
Rear axle case
Tightening
mounting screw and
torque
nut
4-S4
REAR AXLE
W1011635
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 ft-lbs
(3) Rear Wheel
(4) Three Point Linkage
W1011471
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 ft-lbs
(2) Brake Rod (R.H.)
W1011687
77.5 to 90.2 N·m
M6800
7.9 to 9.2 kgf·m
(S)
57.1 to 66.5 ft-lbs
123.6 to 147.1 N·m
M8200
12.6 to 15.0 kgf·m
M9000
91.1 to 108.5 ft-lbs
W1011857
KiSC issued 03, 2008 A