Kubota M6800S Workshop Manual page 179

M6800 · M6800S · M8200 · M9000, WSM
Draining Fuel
• See page 3-S7.
Fuel Tank Connection Hose
1. Remove the cover (2).
2. Remove the connection hose (1).
(When reassembling)
Tightening torque Cover mounting screw
(1) Connection Hose
Rear Wheel and Fenders
1. Place disassembling stand under the transmission case.
2. Remove the three point linkage (4).
3. Remove the rear wheel (3).
4. Disconnect the 6P connector for hazard and tail light.
5. Disconnect the jumper leads for PTO safety switch.
6. Remove the fenders (2).
7. Remove the seat (1).
(When reassembling)
IMPORTANT
• Be sure to assemble the seat switch 2P connector to the
harness connector with Red / Green and Orange / White
color wire. (If equipped OPC system.) (Refer to 9.
ELECTRICAL SYSTEM.)
Tightening torque Rear wheel mounting nut
(1) Seat
(2) Fender
Center Frame
1. Remove the remote valve wire.
2. Remove the draft and position control lever grips (1), (2).
3. Remove the auxiliary speed change lever grip (7).
4. Remove the DT shaft lever grip (4).
5. Remove the three point hitch lowering speed control grip (8) and
PTO lever (3).
6. Remove the center frame (6).
(1) Position Control Lever Grip
(2) Draft Control Lever Grip
(3) PTO Lever
(4) DT Shift Lever Grip
(5) ROPS
2-S14
CLUTCH
W1021533
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
(2) Cover
W1021578
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 ft-lbs
(3) Rear Wheel
(4) Three Point Linkage
W1021709
(6) Center Frame
(7) Auxiliary Speed Change Lever Grip
(8) Three Point Hitch Lowering Speed
Control Grip
W1022020
KiSC issued 03, 2008 A