Kubota M6800S Workshop Manual page 612

M6800 · M6800S · M8200 · M9000, WSM
Preparation 4
1. Remove the floor mat 1 (1), floor mat 2 (2) and cover 1 (3), cover
2 (4).
2. Disconnect the shuttle shift rod (5) and main shift rod (6).
3. Disconnect the shift wire (7).
4. Disconnect the lowering speed adjusting rod (8).
(When reassembling)
• Be sure to adjust the main shift rod length (A), if necessary.
Factory
Shift rod length (A)
spec.
• Be sure to adjust the length (B) and (C) (both sides) of shuttle
shift rod (5) and shift wire (7), if necessary.
Shuttle rod length (B) Factory spec.
Shuttle wire length (C) Factory spec.
NOTE
(When reassembling)
• When install the shaft (10) to the cam (11), be sure to align the
alignment mark (12) in the figure left.
(1) Floor Mat 1
(2) Floor Mat 2
(3) Cover 1
(4) Cover 2
(5) Shuttle Shift Rod
(6) Main Shift Rod
(7) Shift Wire
10-S25
Approx. 275 mm
M6800SQ
10.8 in.
M8200Q Approx. 155 mm
M9000Q 6.10 in.
Approx. 10.0 mm
0.39 in.
Approx. 10.0 mm
0.39 in.
(8) Lowering Speed Adjusting Rod
(9) Lever
(10) Shaft
(11) Cam
(12) Alignment Mark
(13) Speed Change Cover
KiSC issued 03, 2008 A
CABIN
W1021299