Kubota M6800S Workshop Manual page 62

M6800 · M6800S · M8200 · M9000, WSM
Locking Wrench
Application: Use for locking a pinion nut.
NOTE
• This special tool is not provided, so make it referring to the
figure.
A 170 mm (6.69 in.)
B 130 mm (5.12 in.)
C 63.5 mm (2.5 in.)
D 40 mm radius (1.57 in. radius)
E 55 mm (2.17 in.)
F 15 mm (0.59 in.)
G 35 mm (1.38 in.)
H 5 mm (0.2 in.)
I 20 mm (0.55 in.)
J 10 mm (0.39 in.)
K 0.78 rad (45 °)
L 10 mm (0.39 in.)
M 50 mm (1.97 in.)
N 55 mm (2.17 in.)
O 25 mm (0.97 in.)
P 80 mm (3.15 in.)
PTO Propeller Shaft Guide
Application: Use to installing the propeller shaft to 21T gear shaft.
NOTE
• This special tool is not provided, so make it referring to the
figure.
A 24.85 to 24.95 mm dia. (0.9783 to 0.9823 in. dia.)
B 0.26 rad (15 °)
C 0.35 rad (20 °)
D 23.7 to 23.8 mm dia. (0.9331 to 0.9370 in. dia.)
E 20 mm dia. (0.79 in. dia.)
F 2.1 rad (120 °)
G Under 12 mm dia. (0.47 in. dia.)
H 15 mm (0.59 in.)
I 8 mm (0.31 in.)
J 48 mm (1.89 in.)
K Rmax = 25 S
L Rmax = 6.3 S
a 1.0 mm radius (0.039 in. radius)
b 2.0 mm radius (0.079 in. radius)
c 0.8 mm radius (0.031 in. radius)
G-47
G GENERAL
W1034911
W1078372
KiSC issued 03, 2008 A