Kubota M6800S Workshop Manual page 129

M6800 · M6800S · M8200 · M9000, WSM
Camshaft and Balancer Shaft
1. Remove the camshaft set screws and draw out the camshaft (1).
2. Remove the balancer shaft 1 set screws and draw out the
balancer shaft 1 (2).
3. Remove the balancer shaft 2 set screws and draw out the
balancer shaft 2 (6).
(When reassembling)
• When install the balancer shaft 1 and 2, be sure to place the 4th
cylinder piston at the top dead center in compression then, align
all mating marks on each gear to assemble the timing gears, set
the idle gear last.
Camshaft set screw
Tightening torque
Balancer shaft set screw
(1) Camshaft
(2) Balancer Shaft 1
(3) Idle Gear 1
Plate (Gear Case)
1. Remove the three plate mounting screws. Detach the plate (1).
(When reassembling)
• Apply Three Bond 1217D adhesive or equivalent over the
shaded zones on both sides of the gasket that will be sandwiched
between the crankcase and plate.
• Be sure to fix the O-rings (4).
Tightening torque Plate mounting screw
(1) Plate
(2) Gasket
1-S44
ENGINE
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(4) Crank Gear
(5) Idle Gear 2
(6) Balancer Shaft 2
W1027714
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(3) Liquid Gasket
(4) O-ring
W1057656
KiSC issued 03, 2008 A