Kubota M6800S Workshop Manual page 236

M6800 · M6800S · M8200 · M9000, WSM
Shift Fork H-L, C and Shift Fork Rod H-L, C
1. Remove the lock screws (1) and take out the springs (2) and balls
(3).
2. Tap out the spring pin (5).
3. Draw out the shift rod (6) and (8).
4. Take out the shift fork (4) and shift fork (9).
(When reassembling)
• Apply grease to the ball and spring.
• Take care of installing the inter-locking ball (7).
• Apply liquid lock (Three Bond 1372 or equivalent) to the lock
screws (1).
(1) Lock Screw
(2) Spring
(3) Ball
(4) Shift Fork (Creep)
(5) Spring Pin
1st Shaft
1. Tap out the 1st shaft to the front with gears.
(When reassembling)
• Be sure to assemble the 3rd-4th synchronizer unit, set the spline
teeth (18) on the shifter (15) to the key (16) as shown in the
figure.
(1) Ball Bearing
(2) 34T Gear
(3) External Snap Ring
(4) 25T Gear
(5) Inner Ring
(6) 17T Gear
(7) Synchronizer
(8) Ball Bearing
(9) External Snap Ring
(10) Collar
3-S25
TRANSMISSION
(6) Shift Rod (Creep)
(7) Inter-locking Ball
(8) Shift Rod (Hi-Low)
(9) Shift Fork (Hi-Low)
W1016442
(11) Thrust Collar
(12) Needle Bearing
(13) 19T Gear
(14) 1st Shaft
(15) Shifter
(16) Key
(17) Hub
(18) Spline Teeth
(19) Without Spline Teeth
W1016894
KiSC issued 03, 2008 A