Kubota M6800S Workshop Manual page 230

M6800 · M6800S · M8200 · M9000, WSM
Creep Gear and Gear Shaft (If equipped)
1. Tap out the 3rd shaft with gears to the front.
2. Remove the external snap ring (4).
3. Tap out the 15T gear shaft (2).
4. Take out the 43T gear and collar (5).
(1) 47T Gear
(2) 15T Gear Shaft
(3) 43T Gear
Front Drive Shaft
1. Remove the gear case (1) from the clutch housing.
2. Remove the internal snap ring (2), and tap out the idle shaft (4).
3. Remove the oil seal (7) and internal snap ring (8).
4. Draw out the front drive shaft (10).
5. Remove the spring pin (18) and draw out the lever (17).
6. Draw out the shift lever (19).
NOTE
• Take care not to fly out the balls (11) and spring (12) when
take out the shifter (13).
(When reassembling)
• Direct the grooved side of the thrust collars (5) and (15) to the
gear side.
(1) Gear Case
(2) Internal Snap Ring
(3) Bearing
(4) Idle Shaft
(5) Thrust Collar
(6) Sleeve
(7) Oil Seal
(8) Internal Snap Ring
(9) Sleeve
(10) Front Drive Shaft
3-S19
TRANSMISSION
(4) External Snap Ring
(5) Collar
W1020665
(11) Ball
(12) Spring
(13) Shifter
(14) 22T Gear
(15) Thrust Collar
(16) Bearing
(17) Lever
(18) Spring Pin
(19) Shift Lever
W1020811
KiSC issued 03, 2008 A