Kubota M6800S Workshop Manual page 426

M6800 · M6800S · M8200 · M9000, WSM
Position and Draft Linkage
(Reference)
• Serial No. information
M8200 2WD
M8200 4WD
M9000 2WD
M9000 4WD
• In Type A and Type B, holder assembly (17), feed back link (16),
and position connector (10) are different parts.
• An attachment direction varies in the holder assembly (17) with
the type A and B as shown in figure.
A : Type A
1. Remove the clevis pin (1).
2. Remove the circlip (4), (5), (6), (7).
3. Remove the stopper (19) and draw out the rod (3).
4. Remove the stopper (19) and draw out the rod (8). To remove
the O-ring (22) and (23) order by c → b → a as shown in figure.
5. Take out the linkage.
6. Remove the bracket guide assembly (20).
B : Type B
1. Remove the clevis pin (2).
2. Remove the circlip (3), (4), (5), (6).
3. Remove the stopper (19) and draw out the rod (3).
4. Remove the stopper (19) and draw out the rod (8). To remove
the O-ring (22) and (23) order by c → b → a as shown in figure.
5. Remove the cotter pin (21).
6. Take out the linkage.
7. Remove the bracket guide assembly (20).
(When reassembling)
• When install the rods, noting O-ring.
• Apply transmission oil to the O-ring.
• When installing the rod (8), a → b → c let the fix position of O-
ring (22) go to the outside of the hydraulic cylinder body (25) with
the process alternately, and O-ring (24) is assembled into the
rod. (As shown in figure.)
• When assemble the position connector (10) notched section (18)
upward (It is upward the condition that it is attached to the
tractor). (Type B)
• According to procedure of Type B when exchange for hydraulic
link improved in serial No. of Type A and already exchanged.
Bracket guide mounting
Tightening torque
screw
(1) Clevis Pin
(2) Clevis Pin
(3) Rod
(4) Circlip
(5) Circlip
(6) Circlip
(7) Circlip
(8) Rod
(9) Spool Retainer
(10) Position Connector
(11) Draft Link 1
(12) Draft Link 2
(13) Position Balancer
(14) Draft Cam
(15) Connector
8-S26
HYDRAULIC SYSTEM
Type A Type B
Below 10806 Above 10807
Below 53210 Above 53211
Below 10938 Above 10939
Below 55105 Above 55106
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 ft-lbs
(16) Feed Back Link
(17) Holder Assembly
(18) Notched Section
(19) Stopper
(20) Bracket Guide
(21) Cotter Pin
(22) O-ring
(23) Chamfer
(24) O-ring
(25) Hydraulic Cylinder Body
(26) Stopper
(27) Screw
[A] Type A
[B] Type B
W1022805
KiSC issued 03, 2008 A