Install Oil Pump Drive Shaft; Install Rear Oil Seal Retainer; Install Timing Belt Case With Water Pump - Toyota 7M-GE Repair Manual

ENGINE MECHANICAL - Cylinder Block
Qy g&
.
e.\ .-. .a ,j .a. VI ,... :~.~.**-.-. ),
9. INSTALL OIL PUMP DRIVE SHAFT
(a) While turning the drive shaft, insert slowly to avoid
damaging the drive shaft bearing.
(b) Install the bolt.
Torque:
145
kg-cm (10 ft-lb, 14 N*m)
10. INSTALL REAR OIL SEAL RETAINER
Install
a
new
gasket
and rear oil seal retainer with the five
bolts.
Torque: 130 kg-cm (9 ft-lb, 13 N.m)
11. INSTALL TIMING BELT CASE WITH WATER PUMP
(a) Position new
gaskets
on the cylinder block.
(b) Apply sealant to two or three threads of the 10 mm
bolt end.
Sealant: Part No. 08833-00070, THREE BOND 1324
or equivalent
(c) Install the timing belt case with the seven bolts and
three nuts.
12. INSTALL OIL PAN
(See page LU-14)
.13. INSTALL PS PUMP BRACKET