Replacement Of Oil Seals; Replace Crankshaft Front Oil Seal - Toyota 7M-GE Repair Manual

EM-84
ENGINE MECHANICAL A Cylinder Block
'I -
Front, Mark 1
hrust Direction
(b) Drive in the bushing from the inside of the block with
a suitable tool. .
NOTE: The oil hole should be positioned toward the
crankshaft side.
(c) Make sure the front mark of bushing is positioned
toward the front of block.
REPLACEMENT OF OIL SEALS
NOTE.: There are two methods (A and B) of oil seal rep-
lacement.
1.
REPLACE CRANKSHAFT FRONT OIL SEAL
A. If the timing case is removed from the cylinder
block:
(a) Using a screwdriver and hammer, tap out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal.
;'.
SST 09214-60010 and 09506-35010
(cl Apply MP grease to the oil seal lip.
B. If the timing case is installed to the cylinder
block:
(a) Using SST, remove the oil seal.
SST 09308-55010