Installation Of Cold Start Injector; Install Cold Start Injector Tube - Toyota 7M-GE Repair Manual

EFI SYSTEM - Fuel System
FI-83
. .
INSTALLATION OF COLD START INJECTOR
1.
INSTALL COLD START INJECTOR
(7M-GE)
Install a new gasket and the the cold start injector with the
,
two bolts.
Torque: 55 kg-cm (48 in.-lb, 5.4 Nqm)
2.
3.
4.
. .
5.
(7M-GTE)
(a) Connect the connector to the cold start injector.
(b) Install a new gasket and the the cold start injector
with the two bolts.
,Torque: 55 kg-cm 148 in.-lb, 5.4 N-m)
INSTALL COLD START INJECTOR TUBE
Using new gaskets, connect the cold start injector tube to
the delivery pipe and cold start injector. Install the union
bolts.
Torque:
Delivery pipe side
300 kg-cm
(22 ft-lb, 29 N-m)
Cold start injector side 180 kg-cm
(13 ft-lb, 18 N-m)
17M-GE)
CONNECT COLD START INJECTOR CONNECTOR
CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
CHECK FOR FUEL LEAKAGE