Replacement Of Cam Position Sensor Driven Gear; Remove Cam Position Sensor - Toyota 7M-GE Repair Manual

IGNITION SYiTEM - Cam Position Sensor ('IM-GTE)
IG-26.
-_
Groove
/
Matchmark
Drilled Mark
IGO
lGO67i
7. REMOVE CAM POSITION SENSOR
(a) Remove the hold-down bolt.
lb) Pull out the cam position sensor from the cylinder
head.
8. REMOVE O-RING
REPLACEMENT OF CAM POSITION SENSOR
DRIVEN GEAR
1.
GRIND DRIVEN GEAR AND PIN
(a) Align the drilled mark on
the
driven gear with the
groove of the housing.
lb) Place a matchmark on the cam position shaft that
aligns with the groove of the housing.
(cl
Using a grinding wheel, grind the gear and pin.
CAUTION: Be careful not to damage the shaft.
2.
REMOVE PIN AND DRIVEN GEAR
(a) Using a punch and hammer, drive out the pin.
(b)
Remove the driven gear and discard it.
3. INSTALL NEW DRIVEN GEAR AND PIN
(a) Align the matchmark with the groove of the housing.
(b) Align the drilled mark on the new driven gear with the
groove of
the
housing.