Installation Of Fuel Pump; Remove Fuel Pump Filter From Fuel Pump; Install Fuel Pump Filter To Fuel Pump; Install Fuel Tank - Toyota 7M-GE Repair Manual

EFI SYSTEM - Fuel System
FI-79
. .
/
A
Fulcrum Length
2 - 7
mm (0.08 1 0.28 in.)
Pipe
Hose
k
em -m-d-',
--
0 - 3 mm (0 - 0.12 in.)
6. REMOVE FUEL PUMP FILTER FROM FUEL PUMP
(a) Remove the rubber cushion.
(b) Using a'small screwdriver, remove the clip.
(4 Pull out the pump filter.
INSTALLATION OF FUEL PUMP
(See page Fi-78)
1.
2.
INSTALL FUEL PUMP FILTER TO FUEL PUMP
(a) pump filter with the clip.
(b) install the rubber cushion.
INSTALL FUEL PUMP TO FUEL PUMP BRACKET
(a) Insert the outlet port of the fuel pump into the fuel
hose.
(b) Push the lower side of the fuel pump and install the
fuel pump.
3. INSTALL FUEL PUMP BRACKET
Install a new gasket and the pump bracket with the
screws.
Torque: 35 kg-cm (30 in-lb, 3.4 N-m)
4.
INSTALL FUEL TANK
(a) Apply a thin coat of oil to the flare and tighten the
flare nut.
(b) Then using SST, tighten the nut to the specified tor-
que.
SST 09631~22020
Torque: 310 kg-cm (22 ft-lb, 30 N-m)
NOTE: Use a torque wrench with a fulcrum length 30 cm
(1 1 .181 in.).
CAUTION:
l
Tighten the fuel tank mounting bolts, etc. to the
specified torque.
l
Tighten 'the pipe union and flare nut (hose) to the
specified torque.
l
Push in the pipe and insert-type hose to the
specified position, and install the clip to the
specified location.
l
If reusing the hose, reinstall the clip at the original
location,
5.
REFILL GASOLINE
6. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY