Installation Of Cam Position Sensor; Install Cam Position Sensor - Toyota 7M-GE Repair Manual

IG-26 IGNITION SYbTEM
- Cam Position Sensor (7M-GTE)
li 'Jr. .
> ,I_
1 .I..: .' ,,,. 2,,,"--.
(4 Using a' punch and hammei, *peen both ends of the
pin.
I- Groove
INSTALLATION OF CAM POSITION.SENSOR
1. CHECK NO.1 CYLINDER TO TDCXOMPRESSION
2. INSTALL CAM POSITION SENSOR
(a) Install a new O-ring to the cam position sensor.
NOTE: Always use a new O-ring when installing the cam
position sensor.
(b) Align the drilled mark on the driven gear with the
groove of the housing.
(c) Insert the cam position sensor,aligning the center of
the flange with that of the bolt hole on the cylinder
head.
(d) Lightly tighten the hold-down bolt.
. .
3.
INSTALL PS RESERVOIR TANK
Install the PS reservoir tank with bracket with the two
bolts and nut.
4.
INSTALL NO.7 AIR CLEANER HOSE WITH AIR FLOW
METER AND AIR CLEANER CAP
(a) Install the No.7 air cleaner hose with air flow meter
and air cleaner cap.
(b) Install the bolt and tighten the clamps.