Inspection Of Cold Start Injector; Remove Cold Start Injector; Inspect Injection Of Cold Start Injector - Toyota 7M-GE Repair Manual

EFI SYSTEM - Fuel System
Fl-81
4.
Union Bol
Gasket
F1298
(c) Remove the union bolt, fuel tube and two gaskets.
REMOVE COLD START INJECTOR
(7~-GE)
Remove the two bolts and cold start injector with the
gasket.
(7M-GTE)
Remove the two bolts and cold start injector with the
gasket, and disconnect the cold start injector connector.
INSPECTION OF COLD START INJECTOR
1.
(7M-GTE)
INSPECT RESISTANCE OF COLD START INJECTOR
Using an ohmmeter, check the resistance of the injector.
Resistance: 2 - 4 fi
If the resistance is not as specified, replace the cold start
injector.
2.
INSPECT INJECTION OF COLD START INJECTOR
WARNING:
Keep clear of sparks during the test.
(a) Install SST (two unions) to the injector and delivery
pipe with new gaskets and the union bolts.
SST 09268-41045
(b) Connect the SST (hose) to the unions.
SST 09268-41045
(c) Connect the SST (wire) to the injector,
SST
09847-RnnKn