Replace Drive Shaft Bearing; References; Specifications; Warnings, Cautions, Notes - Toyota 7M-GE Repair Manual

INTROkJCT-iON - How to Use This Manual
I IN-3
The procedures are presented in a step-by-ster format:
0 The illustration shows
what
to do and
where
to do it.
0 The task heading tells
what
to do.
0 The detailed text tells
how
to perform the task and gives
other information such as specifications and warnings.
Example:
J
/ Task heading: _ w at to do
tllus tra tion:
what to do and where
2. IF NECCESdY, REPLACE DRIVE SH
FT BEARING
Using SST, replace the No.1 bearing by sing No. 2 bear-
ing as a guide.
SST 092 15-00100
(092 15-00120, 09 15-00150,
/
092 1500160,092 15-002 10, 09 14-00220)
Set part No.
\
i
Compone t part No.
D&/ail text: how to do it
(i) Tightecthe No. 3 and No. 7 bearing cap bolt a little at
a time and in the sequence shown n the figure.
Torque: 500 kg-cm (36 ft-lb, 49 NW)
.-Specification
This format provides the experienced technician with a FAST
TRACK to the information needed. The upper case task heading
can be read at a glance and only when necessary, the text
below it provides detailed information. Impor:ant specifications
and warnings always stand out in bold type.
REFERENCES
References have been kept to a minimum. However, when they
are required you are given the page to go to.
SPECIFICATIONS
Specifications are presented in bold type
the applicable step. You never have to I
look up your specifications. All specifica
Appendix A, Specifications, for quick
WARNINGS, CAUTIONS, N
0 WARNINGS are presented in bold
d indicate there is
a possibility of injury to you or ot
0 CAUTIONS are also presented in bold
possibility of damage to the compone
0 NOTES are separated from the text
type. They provide additional infor
ciently perform the repair.