Inspect And Clean Valve Seats - Toyota 7M-GE Repair Manual

3
EM-50 ENGINE MECHANICAL
- Cylinder Head
1
(e) Check of the valve stem tip for
wear.
If the valve stem tip is worn, regrind it with grinder
or re-
place the valve if necessary.
CAUTION: D6 not grind off more than minimum over-
all length (See page EM-49).
12.
INSPECT AND CLEAN VALVE SEATS
(a) Using a 45" carbide cutter, resurface the valve
seats.
Remove only enough metal to clean the seats.
EM3026
(b) Check the valve seating position.
Apply a thin coat of prussian blue (or white lead) to
the valve face. Install the valve. Lightly press the
valve against the seat. Do not rotate the valve.
(c) Check the valve face and seat for the following:
0 If blue appears 360" around the face, the valve is
concentric. If not, replace the valve.
0 If blue appears 360" around the valve seat, the
guide and seat are concentric.
If not, resurface the seat.
0 Check that the seat contact is on the middle of the
valve face with the following width.
1.0 - 1.4 mm (0.039 - 0.055 in.1
If not, correct the valve seat as follows:
0 If seating is too high on the valve face use 30" and
45" cutters to correct the seat.
l
If seating is too low on the valve face, use and
45" cutters to correct the seat.