Inspection Of Idle Hc/Co Concentration; Check Idle Speed; Check Oxygen Sensor Operation - Toyota 7M-GE Repair Manual

EM-22 ENGINE MECHANICAL - Engine Tune-up
INSPECTION OF IDLE HC/CO
CONCENTRATION (w/ TWC)
NOTE: This check method is used only to determine
whether or not the idle HWCO complies with regulations.
1. INSTALL CONDITIONS
(a) Air cleaner installed
(b) Normal engine operating temperature
(c) All pipes and hoses of intake system connected
(d) All accessories switches off
(e) All vacuum lines properly connected
NOTE: All vacuum hoses for EGR system etc. should be
properly connected
(f) EFI system wiring connectors fully p!ugged
(g) Ignition timing set correctly '.
(h) Transmission in "N" range
6) Tachometer and HWCO meter at hand and calibrated
2. WARM UP ENGINE
Allow the engine to reach normal operating temperature.
3. CONNECT TACHOMETER TO ENGINE
(See page EM- 17)
w 'I"
FI16C
4. CHECK IDLE SPEED
Idle speed :
7M-GE 700 rpm
7M-GTE 800 rpm
5. CHECK OXYGEN SENSOR OPERATION
(a) Using a service wire, short terminals T and the
check connector.
CHECK CONNECTOR LOCATION: See page FI-I 10
(b) Connect the positive (+I probe of a voltmeter to ter-
minal VF of the check connector, and negative (-1
probe to terminal E 1.
(c) Hold the engine speed at 2,500 rpm for approx. 2
minutes.
(d) Then, maintaining engine at 2,500 rpm, count how
many times needle of voltmeter fluctuates between 0
and 5 V.
Minimum needle fluctuation :
8 times for every 10 seconds
If the fluctuation is less than minimum, check the air
induction system for leakage, If necessary, see EFI
SYSTEM.