Exiting The Power Saver Mode; Smart Welcomeyes - Fuji Xerox ApeosPort-V C7776 User Manual

2 Product Overview

Exiting the Power Saver Mode

The machine exits the Power Saver mode by the following instances:
 Pressing the <Power Saver> button on the control panel
 Receiving jobs such as print and fax
 Selecting [Apply] in CentreWare Internet Services
 Setting a document in the document feeder
 Opening the document cover

Detecting human presence by the Smart WelcomEyes of the machine
Note
When the following device is connected to the machine and a user performs the following
operation, the Low Power mode can be deactivated without pressing the <Power Saver>
button.
2
 Touching the IC Card Reader (optional) with a card
Note
Making devices necessary to activate the machine exit the Power Saver mode
The machine is equipped with the feature to save electricity by supplying power only to the
devices necessary to activate the machine when the machine exits the Power Saver mode.
When the <Power Saver> button is pressed, the touch screen is lit on, but the document
feeder and the output devices do not exit the Power Saver mode. Afterwards, by selecting a
service on the touch screen, the machine supplies power only to the devices necessary to
activate the service.
Note
The machine cannot load papers and replace consumables appropriately when the machine
is in the Power Saver mode. Press the <Power Saver> button and then <Machine Status>
button to load papers and replace consumables.

Smart WelcomEyes

The machine provides human detection feature called Smart WelcomEyes. When Smart
WelcomEyes detects human presence within the range of approximately 35 cm from the
machine front, it operates as follows:
 Deactivation of the Power Saver mode without pressing the <Power Saver> button
When the sensor detects human presence, the Power Saver mode is released and then
exited.
 Prohibition of entering the Power Saver mode
While the sensor is detecting human presence, the machine does not enter the Power
Saver mode.
 Deactivation of timer control
82
• When the machine is in the Sleep mode, it takes longer time to exit the Power Saver mode than
when the machine is in the Low Power mode.
• The Sleep mode cannot be deactivated by the operation. When the above device is connected to
the machine, you can make the machine exit the Power Saver mode without pressing the <Power
Saver> button by setting longer time to elapse until the machine enters the Sleep mode.
• When the machine enters the Sleep mode with the IC Card Reader (optional) connected, it may take
longer time to exit the Power Saver mode.
• When the machine receives jobs such as print and print fax, the touch screen is not lit on and only
the output devices exit the Power Saver mode and start to print.
• When the machine receives jobs such as stored print (Secure print, Delayed print, Charge print, and
Private charge print), direct fax, and fax using folder receive, and when you access a folder of the
machine using CentreWare Internet Services, the touch screen is not lit on and only the hard disk
exits the Power Saver mode.