Power Saver Mode; Entering The Power Saver Mode - Fuji Xerox ApeosPort-V C7776 User Manual

Power Saver Mode

The machine is equipped with the Power Saver mode that saves electricity by reducing
power consumption.
The Power Saver feature has two modes: Low Power mode and Sleep mode.
 Low Power Mode
In this mode, the power to the control panel is lowered to save power.
Note
 Sleep Mode
In this mode, the power supply to devices such as hard disk drive is suspended and the power
is lowered more than in the Low Power mode.

Entering the Power Saver Mode

When the machine enters the Power Saver mode, the touch screen is lit off and the <Power
Saver> button on the control panel is lit on.
The machine enters the Power Saver mode by the following instances:
Pressing the <Power Saver> button

 The machine is not operated, data is not received, or a job is not processed until the
machine enters the Power Saver mode.
 Smart WelcomEyes does not detect human presence until the machine enters the Power
Saver mode.
For how to change the interval for entering the Power Saver mode, refer to "1 Before Using the Machine" > "Power Saver
Mode" > "Changing the Interval for Entering Power Saver Mode" in the Administrator Guide.
Note
• When the machine enters the Low Power mode, the power supply to the fusing unit is suspended.
• When the machine displays an error such as paper jams, it does not enter the Power Saver mode.
• When the machine enters the Power Saver mode while a user is authenticated, the machine exits the
authentication mode.
• When the <Power Saver> button is pressed, the machine enters the Power Saver mode after 5
seconds.
• When you press the <Power Saver> button soon after the touch screen is lit off and when the
machine does not enter the Power Saver mode completely, it may take time to exit the mode. Wait a
few seconds until the machine is ready to exit the Power Saver mode and push the <Power Saver>
button again.
• The machine will not enter the Power Saver mode when [Skip Blank Pages] is enabled. For
information on [Skip Blank Pages], refer to "5 Tools" > "Fax Service Settings" > "Fax Control" > "Skip
Blank Pages" in the Administrator Guide.
• Sufficient distance from the machine is required to keep the Power saving state after pressing the
<Power Saver> button. When the specified period of time elapses after pressing the button, the
human motion sensor of the machine starts to detect human presence and then releases the Power
Saver mode.

Power Saver Mode

2
81