Stamp (Adding A Stamp When Scanning A Document) - Fuji Xerox ApeosPort-V C7776 User Manual

1
Select [Reduce/Enlarge].
2
Select a preset ratio, or specify a value.
Note
 Variable %
Specify a ratio in the range from 50 to 400% in
1% increments. To specify a value, use the
numeric keypad or [+] and [-].
 Preset %
 100%
Scans at the same size as the original.
 Auto %
If the scan width of the document exceeds the maximum image size, the scanned image
is rotated or reduced to fit the maximum size.
When the speed dialing is used, the maximum image size will be the size registered in the
Address Number. When speed dialing is not used, the maximum size will be A3.
Note
 Preset ratios
Select from preset scan ratios.
You can change the default values of scan ratios other than [100%] and [Auto %]. For more information, refer to "5 Tools"
> "Fax Service Settings" > "Reduce/Enlarge Presets" in the Administrator Guide.

Stamp (Adding a Stamp when Scanning a Document)

This feature stamps a circle mark at the bottom corner of each document page when it is
fed through the document feeder. This helps you easily check if each page of the documents
has been scanned correctly.
Important • Stamps cannot be affixed on the following documents:
Note
• If a magnification is specified in [Reduce/
Enlarge], [Rotate 90 degrees] does not
function.
• You can specify whether to rotate documents in the System Administration mode. For more
information, refer to "5 Tools" > "Fax Service Settings" > "Fax Control" > "Rotate 90 degrees" in the
Administrator Guide.
- Documents loaded on the document glass
- Documents suspended by pressing the <Stop> button
- Documents suspended by paper jams
- 1-sided documents longer than 600 mm
- 2-sided documents longer than 431.8 mm
- Documents not fed into the document feeder
- Documents suspended due to memory overflow
- Documents that were being scanned when an immediate transmission is suspended
• This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
Layout Adjustment
4
239