Honda Prelude 1993 Service Manual page 1403

Supplemental Restraint System (SRS)
Cable Reel Replacement (cont'd)
CAUTION:
a Bcforo Installing th€ steofng whool. th€ front whe€lg
should be alignod straight ahead.
a Bc aure to install the harnoss wires so that thoy ar€
not pinch6d or intsrfering with other car parts.
a Aftor reassembly. contirm that the whoels aro still
straight ah6ad and that the rteerlng wheel spoke
angle is correct (road test), lf minor spoke angle ad-
iustmont is n€cesaary, do so only by adiustment ot
th€ ti€-lods. not by removing and repositioning tho
ste€ring whael.
11. 2WS: Align the cancel sleeve grooves with the
cable reel projections,
CABLE RE€L
4WS: Be sure that the yellow make on the front
main steering angle sensor rotor faces downwards.
It it doesn't, turn the rotor till it is in the neutral lock
position (see section 17).
Carefully install the cable reel on the steering col-
umn shaft. Then attach the connector holder to the
steering column,
CANCEL SLEEVE
23-326
1 6 .
1 3. Install the steering column upper and lower covers,
14. Center the cable reel.
Do this by first rotating the cable reel clockwise un-
til it stoDs.
Then rotate it counterclockwise (approximately
two turns) until:
a The yellow geaf tooth lines up with the align-
ment mark on the cover.
a The arrow mark on the cable reel label Doints
straight up.
ARROW MARK
ALIGNMENT MABK
15. Install the steering wheel and aftach the csble reel
connector to the cliD.
HORI{ CONNECTOR
CRUISE CONTROL
SET/RESUME
SWITCH CONNECTOR
Connect the horn connector and cruise control
set/resume switch connector.