Connecting The Quad Bri Network Interface Module To The Viewstation Fx Or Vs4000; Connecting The Quad Bri Network Interface Module To The Isdn Bri Network - Polycom ViewStation FX User Manual

Chapter 1
© Polycom, Inc.
NT-1. If you are not connected to an internal phone system, called a
PBX, you will need to connect the ISDN cables from your
ViewStation FX or VS4000 to the Quad BRI module to an ISDN
network termination (NT-1) device, which is connected to the ISDN
wall jack.
For more ISDN information, refer to the Appendix ISDN Information.
Connecting the Quad BRI Network Interface Module to the
ViewStation FX or VS4000
1. Find the cable with the light blue RJ-45 keyed connector on one
end and the green RJ-45 (non-keyed) connector on the other
end.
2. Insert the light blue RJ-45 keyed connector into the light blue
RJ-45 keyed port on the back of the ViewStation FX or VS4000.
3. Insert the green (non-keyed) RJ-45 connector into the green
RJ-45 port labeled
Figure 1-5 shows the peripheral link (P-LINK) side of the BRI
network interface module that connects to the ViewStation FX or
VS4000.
Figure 1-5. BRI Network Interface Module (P-LINK side)
Connecting the Quad BRI Network Interface Module to the
ISDN BRI Network
1. Attach your RJ-45 network cable(s) from Port 1 on your ISDN
BRI network to the connector labeled ISDN S/T on the BRI
network interface module.
xon the network interface module.
17 ViewStation FX/VS 4000 User's Guide
Getting Started