Using Two Numbers - Polycom ViewStation FX User Manual

Chapter 1

Using Two Numbers

© Polycom, Inc.
Highlight the Disconnect Video Call icon and press the
the remote. If the call was made with a number that is not in your
address book, a dialog box gives you the opportunity to add the
number. If you select Yes, the system takes you to the address book
where you can enter the information. If you select "No", the main
screen appears on your monitor.
Note If you stay in this screen for 60 seconds without pressing the
button to stay in the call or hang up, the call is
disconnected.
You can also place a video call using the Address Book or Speed
Dial. For more information, see the Address Book section of Chapter
2, Using the ViewStation FX and the
To manually place a video call using two numbers, complete the
following:
1. Select the Video Call icon.
2. To enter the first ISDN number of the party you are calling, use
the numeric keypad on the remote control.
To clear an entry, use the arrow buttons to move the highlight
box to the clear icon on the screen, and press the SELECT
button (or the CALL•HANG-UP button). To clear part of an entry
from the right, press the left arrow once for each character you
wish to delete.
3. To enter the second number:
– For an ISDN number one digit greater than the first, press
the RIGHT arrow button to enter that number, then skip to
step 5.
– For an ISDN number which is the same as the first, press
the DOWN arrow button, then skip to step 5.
– Otherwise, press the DOWN arrow button to move the
orange highlight box to the second line of the screen. Use
the LEFT arrow button on the remote control to delete
numbers to the left and the numeric keypad to enter the
second ISDN number of the party you are calling.
4. Press the SELECT button (or the CALL•HANG-UP button) to
place the call.
VS4000.
39 ViewStation FX/VS 4000 User's Guide
Getting Started
button on