Polycom ViewStation FX User Manual page 38

Chapter 1
ViewStation FX/VS 4000 User's Guide
Figure 1-13. Video Network Setup Screen
You can set the following options on this screen:
• RS-366 Dialing—Disable this option if you are using your DCE
to dial the call or if you have a dedicated connection to the far
site.
Enable this option if you want to call from the ViewStation FX or
VS4000 through the DCE connection to the far end video
conferences system.
Note If the RS-366 Dialing option is enabled, you need to select
Dialing Speeds (see Dialing Speeds) You also need to set
dialing prefixes and suffixes (see Advanced Dialing
section).
• V.35 Ports Used—Select 1 if you are placing only 1-channel
calls. Select 1+2 if you are placing 2x56 kbps or 2x64 kbps
channel calls.
• Dialing Protocol—RS-366 appears as the dialing protocol if the
RS-366 Dialing option is enabled. If the RS-366 Dialing option is
disabled, the Dialing Protocol does not appear.
• Broadcast Mode—Enable or disable H.331 broadcast mode if
the ViewStation FX or VS4000 is connected to the network via
satellite.
When you have finished, highlight the Save icon and press the
button on the remote control.
24
Getting Started
www.polycom.com