Kyocera Mita KM-1505 Service Manual page 50

Maintenance
item No.
U109 Setting the drum type
Description
Sets the type of the drum installed in the copier.
Purpose
To prevent variations in halftone due to differences in drum sensitivity.
Method
Press the start key.
Setting
1. Select the drum type using the zoom +/– keys.
Display
A
b
C
d
Initial setting: b
2. Press the start key. The setting is set. The indication for selecting a maintenance item No. appears.
Completion
To exit this maintenance item without changing the current setting, press the stop/reset key. The indication for
selecting a maintenance item No. appears.
U110 Checking/clearing the drum count
Description
Displays the drum counts for checking, clearing or changing the figure, which is used as a reference when
correcting the main charger potential output.
Purpose
To check the drum status. Also used to clear the count after replacing the drum during regular maintenance.
Since the count was cleared before shipping, do not clear it when installing.
Method
1. Press the start key.
2. Select the item by lighting a copy exposure indicator using the copy exposure adjustment keys.
Copy exposure indicator Description
Exp. 1
Exp. 3
Exp. 5
Clearing
1. Light exp. 5.
2. Press the start key. The count is cleared, and the indication for selecting a maintenance item No. appears.
Setting
1. Change the count using the zoom +/– keys.
2. Press the start key. The count is set, and the indication for selecting a maintenance item No. appears.
Completion
To exit the maintenance mode without changing the count, press the stop/reset key. The indication for selecting
a maintenance item No. appears.
Description
Description
Type A
Type b
Type C
Type d
First 3 digits
Last 3 digits
Clearing the count
Setting range Initial setting
000 to 999 000
000 to 999 000
— — — — — —
2BT
1-4-19