Kyocera Mita KM-1505 Service Manual page 23

Remove the pins holding light source units 1 and 2.
6. Remove the tapes and two pins for light source
unit 1 and 2.
7. Open the front cover and store the removed pins
by securing them on the inside of the cover. The
storing locations of the pins are marked inside the
front cover.
Caution: Be sure to refit the pins whenever the
copier is moved.
Remove the pad inside the machine.
8. Remove the pad. (This step is not necessary for
metric specification copiers.)
Pins
Figure 1-3-7
Pins
Figure 1-3-8
Pad
Figure 1-3-9
2BT
Tapes
1-3-5