Adjusting The Scanner Center Line - Kyocera Mita KM-1505 Service Manual

(9) Adjusting the scanner center line

Perform the following adjustment if there is a regular error between the center lines of the copy image and original.
U034
U067
(P. 1-6-9)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "067" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Press the size select key and the
machine enters the test copy mode.
Place an original and press
the start key to make a test copy.
Is the scanner
center line correct?
Press the stop/reset key to
exit maintenance mode.
Start
For copy example 1, increase
the value using the zoom (+) key.
No
For copy example 2, decrease
the value using the zoom (–) key.
Setting range: –39.0 – +39.0
Yes
Initial setting: 0
Changing the value by 1 moves
the center line by 0.17 mm.
End
Scanner center line
Original Copy
example 1
Figure 1-6-42
Press the start key.
The new setting
is stored.
2BT
Copy
example 2
1-6-25