Kyocera Mita KM-1505 Service Manual page 122

2BT
6. Remove the screw holding the upper
developing seal and then the seal.
7. Pull the drum shaft out and remove the drum.
• Detach the drum horizontally.
8. Replace the drum and refit all the removed
parts.
• When replacing the drum, insert a sheet of
paper between the drum and developing
roller to prevent damage to the drum.
• Check the letter indicating the drum type
printed on the new drum flange.
• Securely insert the drum shaft as far as it
will go. When turning the drum shaft, turn it
in the direction indicated by the arrow
marked on the image formation unit frame.
• Rotate the drum in its rotational direction
and check that the cleaning blade does not
flip up.
9. After replacing the drum, run maintenance
items below.
• U109 "Setting the drum type " (set to the
drum type printed on the new drum flange)
• U110 "Checking/clearing the drum
count"(clear the drum count)
• U111 "Checking/clearing the drum drive
time" (clear the value)
1-6-30
Upper developing seal
Figure 1-6-49
Drum
Drum shaft
Figure 1-6-50