Kyocera Mita KM-1505 Service Manual page 57

2BT
Maintenance
item No.
U207 Checking the operation panel keys
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key.
2. "1" appears on the copy quantity display and the leftmost LED on the operation panel lights.
3. As the keys on the operation panel are pressed in order from the left to right, the figure shown on the copy
quantity display increases in increments of 1. If there is an LED corresponding to the key pressed, the LED
will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
5. When the LEDs go off, press the start key. All the LEDs light for 10 seconds again.
Completion
Press the stop/reset key. The indication for selecting a maintenance item No. appears.
• After this check starts, the operation cannot be canceled until all the keys are checked.
U208 Setting the paper size
Description
Sets the size of paer loaded in the drawer.
Purpose
Used when changed the paper size in the drawer.
Method
1. Press the start key.
2. Select the paper size using the zoom +/- keys.
Display
A4r/814
A5r/811
FOL/5H8
3.Press the start key. The setting is set.
Completion
To exit this maintenance mode without the current setting, press the stop/reset key while a selection item is
displayed. The indication for selecting a maintenance item No. appears.
1-4-26
Description
Paper size
" × 14"
1
A4R/8 /
2
" × 11"R
1
A5R/8 /
2
" × 8
1 1
Folio/5 / / "R
2 2