Kyocera Mita KM-1505 Service Manual page 109

7. Loop the scanner wires around the outer grooves in the pulleys on the mirror 2 frame, winding from above to
below. .............................................................................................................................................................. 1
8. Hook the round terminals onto the catches inside the scanner unit. .............................................................. 2
9. Loop the outer ends of the scanner wires around the grooves in the scanner wire pulleys at the right of the
scanner unit, winding from below to above. .................................................................................................... 3
10. Loop the scanner wires around the inner grooves in the pulleys on the mirror 2 frame, winding from above to
below. .............................................................................................................................................................. 4
11. Wind the scanner wires around the grooves in the scanner wire guides at the right of the scanner unit. ....... 5
12. Hook the round terminals onto the scanner tension springs. .......................................................................... 6
13. Remove the scanner wire stoppers and frame securing tools.
14. Gather the scanner wires toward the locating balls.
15. Move the mirror 2 frame from side to side to correctly locate the wires in position.
16. Refit all the removed parts.
Figure 1-6-28
Figure 1-6-29
2BT
1-6-17