Kyocera Mita KM-1505 Service Manual page 86

2BT
(12) The leading edge of
the image is sporadi-
cally misaligned with
the original.
Causes
1. Registration clutch, bypass paper feed clutch
or paper feed clutch installed or operating
incorrectly.
(13) Paper creases.
Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
(14) Offset occurs.
Causes
1. Defective cleaning blade.
2. Defective pressure springs.
3. Incorrect fixing temperature.
1-5-16
Causes
1. Registration clutch, bypass paper feed clutch
or paper feed clutch installed or operating
incorrectly.
Check the installation position and operation of the registration
clutch, bypass paper feed clutch and paper feed clutches. If any of
them operates incorrectly, replace it.
Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
Check the paper storage conditions.
Check the paper storage conditions.
Replace the pressure springs.
Causes
1. Defective cleaning blade.
2. Defective pressure springs.
3. Incorrect fixing temperature.
Replace the cleaning blade (see page 1-6-31).
Replace the pressure springs.
Run maintenance item U161 and check the fixing temperature.
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures