Configuring Mld Snooping Port Functions - HP 1920 Series User Manual

Configuring MLD snooping port functions

1.
2.
3.
4.
Table 87 Configuration items
Downloaded from www.Manualslib.com
Select Network > MLD snooping from the navigation tree.
Click the Advanced tab.
Figure 245 Configuring MLD snooping port functions
Configure the parameters as described in
Click Apply.
Item Description
Select the port on which advanced MLD snooping features will be configured. The port
can be an GigabitEthernet port or Layer 2 aggregate interface.
After a port is selected, advanced features configured on this port are displayed at the
lower part of this page.
Port
TIP:
Advanced MLD snooping features configured on a Layer 2 aggregate interface do not
interfere with configurations on its member ports, nor do they take part in aggregation
calculations. The configuration on a member port of the aggregate group does not take
effect until the port leaves the aggregate group
Specify the ID of the VLAN in which port functions are to be configured.
VLAN ID
The configurations made in a VLAN take effect on the ports only in this VLAN.
Configure the maximum number of IPv6 multicast groups on a port.
With this feature, you can regulate IPv6 multicast traffic on the port.
IMPORTANT:
Multicast Group
Limit
When the number of IPv6 multicast groups on a port exceeds the limit that you are setting,
the system deletes all the IPv6 forwarding entries related to that port from the MLD snooping
forwarding table. The receiver hosts to that port can join the IPv6 multicast groups again
before the number of IPv6 multicast groups on this port reaches the limit.
manuals search engine
Table 87.
272