Logging In To The Cli; Cli Commands - HP 1920 Series User Manual

Logging in to the CLI

The login process requires a username and password. The default username for first time configuration
is admin, no password is required. Usernames and passwords are case sensitive.
To log in to the CLI:
1.
2.
3.

CLI commands

This section contains the following commands:
Downloaded from www.Manualslib.com
Press Enter. The Username prompt displays:
Login authentication
Username:
Enter your username at the Username prompt.
Username:admin
Press Enter. The Password prompt appears.
Password:
The login information is verified, and the following CLI menu appears:
<HP 1920 Switch>
If the password is invalid, the following message appears and process restarts.
% Login failed!
Task
Display a list of CLI commands on the device.
Reboot the device and run the default configuration.
Configure VLAN-interface 1 to obtain an IPv4 address through
DHCP or manual configuration.
Configure VLAN-interface 1 to obtain an IPv6 address through
the autoconfiguration function or manual configuration.
Modify the login password.
Log out of the system.
Download the Boot ROM image or system software image file
from the TFTP server and specify it as the startup configuration
file.
Reboot the device and run the main configuration file.
View the summary information about the device.
Ping a specified destination.
Tear down the current connection and quit the system.
manuals search engine
Command
?
initialize
ipsetup { dhcp | ip-address ip-address { mask
| mask-length } [ default-gateway
ip-address ] }
ipsetup ipv6 { auto | address { ipv6-address
prefix-length | ipv6-address/prefix-length }
[ default-gateway ipv6-address ] }
password
quit
upgrade [ ipv6 ] server-address
source-filename { bootrom | runtime }
reboot
summary
ping [ ipv6 ] host
quit
24