Mstp Configuration Example; Network Requirements - HP 1920 Series User Manual

MSTP configuration example

Network requirements

As shown in
•
•
•
Downloaded from www.Manualslib.com
Field
PortTimes
BPDU Sent
BPDU Received
Protocol Status
Protocol Std.
Version
CIST Bridge-Prio.
MAC address
Max age(s)
Forward delay(s)
Hello time(s)
Max hops
Figure 183, configure MSTP as follows:
All devices on the network are in the same MST region.
Packets of VLAN 10, VLAN 20, VLAN 30, and VLAN 40 are forwarded along MSTI 1, MSTI 2,
MSTI 3, and MSTI 0, respectively.
Switch A and Switch B operate at the distribution layer. Switch C and Switch D operate at the access
layer. VLAN 10 and VLAN 20 are terminated on the distribution layer devices, and VLAN 30 is
terminated on the access layer devices, so the root bridges of MSTI 1 and MSTI 2 are Switch A and
Switch B, respectively, and the root bridge of MSTI 3 is Switch C.
manuals search engine
Description
Major parameters for the port:
•
Hello—Hello timer.
•
MaxAge—Max Age timer.
•
FWDly—Forward delay timer.
•
MsgAge—Message Age timer.
•
Remain Hop—Remaining hops.
Statistics on sent BPDUs.
Statistics on received BPDUs.
Whether MSTP is enabled.
MSTP standard.
MSTP version.
Priority of the current device in the CIST.
MAC address of the current device.
Maximum age of a configuration BPDU.
Port state transition delay, in seconds.
Configuration BPDU transmission interval, in seconds.
Maximum hops of the current MST region.
199