Configuring The Mac Address Table; Overview; How A Mac Address Entry Is Created - HP 1920 Series User Manual

Configuring the MAC address table

MAC address configurations related to interfaces apply to Layer 2 Ethernet interfaces and Layer 2
aggregate interfaces only.
This document covers only the configuration of unicast MAC address entries, including static, dynamic,
and blackhole entries.

Overview

To reduce single-destination packet flooding in a switched LAN, an Ethernet device uses a MAC address
table to forward frames. This table describes from which port a MAC address (or host) can be reached.
Upon receiving a frame, the device uses the destination MAC address of the frame to look for a match
in the MAC address table. If a match is found, the device forwards the frame out of the outgoing interface
in the matching entry. If no match is found, the device floods the frame out of all but the incoming port.

How a MAC address entry is created

The device automatically learns entries in the MAC address table, or you can add them manually.
MAC address learning
The device can automatically populate its MAC address table by learning the source MAC addresses of
incoming frames on each port.
When a frame arrives at a port (for example, Port A), the device performs the following tasks:
1.
2.
3.
The device performs this learning process each time it receives a frame from an unknown source MAC
address until the MAC address table is fully populated.
Manually configuring MAC address entries
With dynamic MAC address learning, a device does not distinguish between illegitimate and legitimate
frames. For example, when a hacker sends frames with a forged source MAC address to a port different
from the one with which the real MAC address is associated, the device creates an entry for the forged
MAC address, and forwards frames destined for the legal user to the hacker instead.
To improve port security, you can manually add MAC address entries to the MAC address table of the
device to bind specific user devices to the port.
Downloaded from www.Manualslib.com
Verifies the source MAC address (for example, MAC-SOURCE) of the frame.
Looks up the source MAC address in the MAC address table.
If an entry is found, the device updates the entry.
If no entry is found, the device adds an entry for MAC-SOURCE and Port A.
When the device receives a frame destined for MAC-SOURCE after learning this source MAC
address, the device finds the MAC-SOURCE entry in the MAC address table and forwards the
frame out of Port A.
manuals search engine
173