Configuring Switch B; Verifying The Configuration - HP 1920 Series User Manual

Configuring Switch B

1.
2.
3.
4.
5.
6.
7.

Verifying the configuration

1.
Downloaded from www.Manualslib.com
(Optional.) Enable LLDP on port GigabitEthernet 1/0/1. By default, LLDP is enabled on Ethernet
ports.
Set the LLDP operating mode to Tx on GigabitEthernet 1/0/1:
a. From the navigation tree, select Network > LLDP.
By default, the Port Setup tab is displayed.
b. Click the icon for port GigabitEthernet 1/0/1.
c. Select Tx from the LLDP Operating Mode list.
Click Apply.
A progress dialog box appears.
Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Figure 212 Setting the LLDP operating mode to Tx
Enable global LLDP:
a. Click the Global Setup tab.
Select Enable from the LLDP Enable list.
b.
Click Apply.
A progress dialog box appears.
Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Display the status information of port GigabitEthernet 1/0/1 on Switch A:
From the navigation tree, select Network > LLDP.
a.
By default, the Port Setup tab is displayed.
manuals search engine
239