HP 1920 Series User Manual page 58

4.
5.
Downloaded from www.Manualslib.com
Figure 33 Configuring stack ports on Switch B
Switch B becomes a member device.
On Switch C, configure GigabitEthernet 1/0/1 (the port connected to Switch B) as a stack port:
a. Select Stack from the navigation tree of Switch C.
b. In the Port Settings area on the Setup tab, select GigabitEthernet1/0/1.
c. Click Enable.
Figure 34 Configuring a stack port on Switch C
Switch C becomes a member device.
On Switch D, configure GigabitEthernet 1/0/1 (the port connected to Switch B) as a stack port:
a. Select Stack from the navigation tree of Switch D.
b. In the Port Settings area on the Setup tab, select GigabitEthernet1/0/1.
c. Click Enable.
Switch D becomes a member device.
manuals search engine
45