Configuring Stack; Overview; Configuration Task List - HP 1920 Series User Manual

Configuring stack

Overview

The stack management feature allows you to configure and monitor a group of connected devices by
logging in to one device in the stack, as shown in
Figure 25 Stacking devices
To set up a stack for a group of connected devices, you must log in to one device to create the stack. This
device is the master device for the stack. You configure and monitor all member devices on the master
device. The ports that connect the stack member devices are called stack ports.

Configuration task list

Perform the tasks in
Table 5 Stack configuration task list
Downloaded from www.Manualslib.com
Table 5 to configure a stack.
Task
Configuring the master device of a stack:
Configuring global parameters of a stack
Configuring stack ports
manuals search engine
Figure 25.
Remarks
Required.
Configure a private IP address pool for a stack and establish the
stack, and meantime the device becomes the master device of the
stack.
By default, no IP address pool is configured for a stack and no stack
is established.
Required.
Configure the ports of the master device that connect to member
devices as stack ports.
By default, a port is not a stack port.
39