Footrest Latch; Adjusting The Lower Leg Length - Otto Bock Skippi Instructions For Use Manual

Operation
Fig. 23

Footrest latch

Adapting the footrests to the lower leg length
1. Use a size 4 Allen wrench to loosen the screws on the
back of the footrest bar (Fig. 24, left).
2. Move the footrest up or down to adapt it to the individual
lower leg length and seat cushion thickness.
3. If necessary, the angle of the footplate can be changed
by loosening the attachment screw on the rear side of
the footrest bar (Fig. 24, right).
4. Re-tighten the screws properly.
132 | Ottobock
INFORMATION
When adjusting the footrest height, ensure that the footrest
bar is inserted into the swivel segment by at least 60 mm.
After completing the adjustment, tighten the set screw with
a torque of 8 Nm.
Fig. 24

Adjusting the lower leg length

Moving the footrest holder
The footrest holders can be moved together in the longitudi-
nal direction (Fig. 25) and individually/independently in the
lateral direction (Fig. 26).
1. Loosen the corresponding two screws on the seat frame.
2. Move the footrest holder to the desired position.
3. Re-tighten the screws properly.
Skippi