Battery Pack; Bottom Of The Battery Pack - Otto Bock Skippi Instructions For Use Manual

Operation
Fig. 33

Battery pack

Due to the sealed design, the Gel technology used fulfills the
latest safety and environmental compatibility provisions.
The battery packs are integrated in separate battery packs
for additional safety and improved handling. The batteries
were designed for high cycle stability and are particularly
well suited to traction operation due to the special lead
plates.
Please contact your authorised specialist dealer to replace
or dispose of the batteries (batteries in the battery pack).
The batteries must be replaced as complete units (battery
packs).
146 | Ottobock
Proceed as follows to remove/install the battery packs:
1. Release the seat lock by pulling on the release strap and
folding the locking bar back at the same time (Fig. 10).
2. The battery packs are now accessible. Remove the bat-
tery packs (Fig. 11).
3. Place the new battery packs back into the drive unit. En-
sure that the red arrows on the battery packs point in the
driving direction and that the plug contacts (Fig. 34) en-
gage with the battery contacts.
4. The locking lever should be engaged again to prevent
the battery packs from falling out (Fig. 10).
Fig. 34

Bottom of the battery pack

Skippi