Footrest - Otto Bock Skippi Plus Instructions For Use Manual

Operation
Changing the control panel mounting side
INFORMATION
The control panel mounting side may only be changed by
authorised personnel.
The standard configuration has the control panel mounted
on the right side. It can also be mounted on the left side of
the power wheelchair if the user so desires.

6.1.5 Footrest

CAUTION
Risk of pinching. Ensure that your fingers are not in the
danger area when flipping the footrests up or down. The
footrests may only be removed entirely from their holders
when the wheelchair is being transported.
Removing the footrests
1. Press the footrest latch (see fig. 23).
2. Pull the footrest up and remove it.
Installing the footrests
1. Slide the footrest into the holder from above until the
latch clicks in place.
46 Ottobock
|
Fig. 23 Footrest latch
Adapting the footrests to the lower leg length
1. Use a size 4 Allen wrench to loosen the screws on the
back of the footrest bar (fig. 24, left).
2. Move the footrest up or down to adapt it to the individual
lower leg length and seat cushion thickness.
3. The footrest angle can be changed when the locking le-
ver is released (fig. 24, right).
4. Re-tighten the screws properly.
Skippi Plus