Otto Bock Skippi Instructions For Use Manual page 149

NOTICE
Risk of battery damage. Setting the characteristic curve
incorrectly can result in permanent damage to the battery.
The following safety instructions must be observed when
handling the battery charger:
„ Always place the rubber feet of the charger on a level
surface.
„ Protect the charger from direct sunlight to avoid addi-
tional heating of the device.
„ The charger must be located in a dry and well ventilated
location. Avoid letting dust and dirt enter the battery
charger. This can impair the battery charger functionality.
„ Use a dry cloth to clean the battery charger.
6.5.3 Charging Process
To charge the batteries, proceed as follows:
1. Turn the control unit on the power wheelchair off.
2. Plug the charger into the charging receptacle on the
power wheelchair control panel (see Fig. 30, item 10).
Skippi
3. Connect the battery charger to a wall outlet. The batter-
ies will start charging automatically, and the current
charge status is indicated on the LED's of the battery
charger (see Tab. 5).
4. After completion of the charging process: Disconnect
the mains plug and the charger plug on the control panel.
5. Turn on the control unit; the power wheelchair is now
ready to use.
Please see the instructions for use supplied with the battery
charger for further details on use and on the LED indicators.
Operation
Ottobock 149
|