Required Accessories; Disassembling The Power Wheelchair; Fig. 5 - Otto Bock Skippi Instructions For Use Manual

Transportation and Storage

Fig. 5

Rear eyebolts, front eyebolts

5.1.1 Required Accessories

To use the power wheelchair as a seat in a wheelchair ac-
cessible vehicle, additional accessories have to be mounted
(491S00=SK024 Anchor Point Kit).
The qualified personnel which fit the wheelchair can provide
more information.
5.2

Disassembling the power wheelchair

NOTICE
Risk of cable damage. Take care to ensure that cables
are not pinched when the wheelchair is disassembled/as-
sembled.
120 | Ottobock
INFORMATION
The frame and drive unit must not be separated if the
Skippi is equipped with one of the following electric op-
tions:
„ Seat height adjustment
„ Electric seat tilt
„ Electric back angle adjustment
In this case, skip steps no. 7/8 below.
You can reduce the transportation size of the power wheel-
chair in a few simple steps in order to transport it. Always
put the respective parts which were removed down carefully.
Please observe the following order for disassembly:
1. Remove the footrests (Fig. 6).
2. Remove the control panel from the armrest and carefully
lay it down on the ground (Fig. 7).
Skippi