Application Menu Settings; Time-Controlled Functions Application - Sartorius la series Operating Instructions Manual

Application Menu Settings

(App)
Purpose
To configure the balance, i.e., adapt
the balance to individual requirements
by selecting from a list of parameter
options in a menu. You can block
access to this menu by assigning a
password.
Features
The simple weighing function is
available at all times. You can select
one from each of the following
application groups. This means
a number of combinations
are possible.
Application 1
– Toggle between 2 weight units
– Counting
– Weighing in percent
– Animal weighing
– Recalculation
– Calculation
– Density determination
Application 2
– Checkweighing
– Time-controlled functions
Application 3
– Totalizing
– Formulation
– Statistics
In addition, you can assign 2 extra
functions to each of the soft keys,
in some cases (depends on the Setup
configuration):
– 2nd tare memory
– Identification code
– Manual totalizing
– Product data memory
Factory Settings
The factory-set configurations
are marked with an "o " in the list
starting on page 20.
Preparation
Select the Setup program:
Press M
> SETUP SELECTION
is displayed
Select the application menu:
Press the App soft key
If a password has been assigned:
> The password prompt is displayed
Enter the password
Confirm the password entered:
Press the l soft key
> The application menu is displayed
(1st menu level):
$ Select the next group:
Press the q soft key (arrow down)
$ To select the previous item in the
group: press Q soft key (arrow up)
$ To select one item lower in
the group: Press the O soft key
(arrow right)
$ To return to the next level up: Press
the o soft key (arrow left)
$ Confirm the selected menu item:
Press the l soft key
$ Move the highlight bar to the first
menu item on the list: Press c
$ Toggle to the Setup:Balance menu
(see also page 28):
Press the Menu soft key
Configuring the Balance
Additional Functions
Save settings and exit the
application menu:
Press the oo soft key
> Restart the application
Print parameter settings:
– When the application menu
is displayed: Press p
> Printout (Example)
Application 1
--------------------
Toggle wt. units
Weight unit 1
Grams /g
Display accuracy 1
All digits
Weight unit 2
Grams /g
Display accuracy 2
All digits
Application 2
--------------------
Off
etc.
To reset parameters to the
factory settings: see the following
chapter, entitled "Balance
Operating Menu," and set menu
code 9 1 1
17