Sartorius la series Operating Instructions Manual page 112

Pin Assignments for the Female Interface Connector
Pin Input Function
[8-8-1]
15 p key
t key
16
17 q key
18 v key
19 c key
112
Interface Port Input/Output
You can connect a checkweighing
display and a remote universal
switch to the interface port (factory
setting).
When you connect a remote
universal switch, you need to change
the following parameters.
Output Function
[8-8-2]
Remote universal switch (see below)
Control output port 1: lighter
Control output port 2: equal
Control output port 3: heavier
Control output port 4: "set"
Remote Universal Switch
Function Menu setting
p key
[8-4-1]
t key
[8-4-2]
q key
[8-4-3]
F1 Function key
[8-4-4]
c key
[8-4-5]
F2 Function key
[8-4-6]
Bar code scanner,
PC keyboard
[8-4-7]
See "Pin Assignment Chart"
in the chapter entitled "Overview"
for detailed information.
Printing an ISO/GLP/GMP-
compliant Record
In the Setup menu, you can configure
whether
– no ISO/GLP/GMP-compliant
record will be printed
( , )
Off [8-10-1]
– an ISO/GLP/GMP-compliant
record will be printed only after
calibration/adjustment
(
Only for
calibration/
adjustment, [8-10-2]
– every printout will be an ISO/
GLP/GMP-compliant record
( ,
Always on [8-10-3]
Undoing All Parameter Changes –
Reset Function
There is a factory setting for each
parameter. In the Setup menu, you
can configure whether
– factory settings will be restored
after exiting Setup (
Factory
settings, [9-1-1]
)
)
)