Disassembling And Reassembling The Control Head - Tait TM8100 mobiles Service Manual

5.4

Disassembling and Reassembling the Control Head

5.4.1 Control Head with Graphical Display
Figure 5.8 Speaker orientation and connectors of the control-head board (graphical display)
legs of the
speaker clamp
speaker terminals
TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
Disassemble only as much as necessary to replace the defective parts.
Reassembly is carried out in reverse order of the disassembly.
The circled numbers in this section refer to the items in
page 149.
The connectors of the control-head board and the orientation of the speaker
and speaker clamp are illustrated in
1. With your fingers, pull off the volume control knob
Do not use any tools as this might cause damage.
2. Unscrew the two screws
3. Disconnect the control-head loom
4. If an optional circuit board is fitted, unplug it from the control-head
F
board (refer to
5. Note whether the speaker is connected or disconnected. If it is
connected, disconnect the speaker cable from the speaker connector
of the control-head board
must be returned to the customer in its original configuration.
6. Release the lock of the LCD connector and unplug the loom of the
1@
LCD assembly
through a slot in the space frame
pads for leads of
concealed microphone
connector for speaker
Figure 5.8.
B
and remove the adaptor flange
D
.
Figure 5.8).
F
(refer to Figure
(refer to Figure 5.8). Note that the loom runs
J
.
connector for
loom of LCD assembly
connector for
control-head loom
Disassembly and Reassembly
Figure 5.9 on
1&
.
C
.
5.8). Note that the radio
connectors for
optional circuit board
3470z_01
147