Installing The Control Head Solution - Tait TM8260 Installation And Programming Manual

3.9

Installing the Control Head Solution

To install a single graphical-display control head, see
Display Control-Head"
To install dual graphical display control-heads, follow the installation
instructions in the upgrade kit (see
page
To install a hand-held control head, see
Head" on page
Installing a Graphical Display Control-Head
To install a single control head with graphical-display to dual radio bodies:
■
■
■
The following steps show how to connect the control head remote interface
Assembling the
Control Head
to the control head.
Interface
1.
2.
3.
4.
32 Installing a Dual-Radio System
below.
5).
35.
assemble the control-head interface
mount the control head using the U bracket, then
install the remote cable.
Undo the two Torx T-
20 screws on the adap-
tor flange of the con-
trol head, and remove
the adaptor flange.
Keep the two screws
for step 6.
Unplug the control-
head loom.
The adaptor flange and
control-head loom are
not used for the remote
control-head
installation.
You can change the control head orientation by changing the control-
head loom to the opposite connector. For more information, refer to the
remote control-head installation instructions (IPN 402-00020-xx, avail-
able from http://support.taitradio.com).
"Installing a Graphical
"Associated Documentation" on
"Installing a Hand-Held Control
TM8260 Installation and Programming Guide
© Tait Limited October 2014