Door Alarms - DigiTech DigiGate-700 User Manual

DigiGate-700 for Windows
™
Figure 2-52
This section applies ONLY if you have individual Door Alarms. If there are NO individual Door Alarms
at your location, skip this section.
1. Click on the SysCon Setup tab of the Setup
Menu , then Click on the Door Alarms
button. Figure 2-52.
2. This will open the Door Alarm Options
window. Figure 2-53.
NOTE: This screen is used to set the way the
DigiGate-700 for Windows system handles
vacant units when Door Alarms are present.
The Yes check box, under the Should Units
be ... prompt, is a system setup value, meaning
it will always be active. The Arm/Disarm
Vacant Units selection list is an immediate
action and can be used at any time.
3. Click on the Yes check box to Select the option
you want. Checked means that units will be
disarmed when a tenant moves out and the unit
is vacated, then rearmed when a new tenant is
moved in. Unchecked means that the unit will
remain armed when vacant. Figure 2-53.
DigiGate-700
for Windows
™
- User's Guide
®

Door Alarms

®
Figure 2-53
4. To arm or disarm all vacant units at your
location, click on the appropriate button in the
list, Arm Vacant Units or Disarm Vacant
Units then Click on the OK button to immedi-
ately arm or disarm the vacant units.
NOTE: This option allows very flexible
control over your units. For example: you may
want your vacant units disarmed during the day,
allowing you to show them to prospective
renters, and have the same units armed when
your office is closed to notify of any attempt at
entry. This can be easily accomplished by using
this screen to disarm the vacant units when you
arrive and then arm the vacant units whenever
you leave.
5. Click on Cancel to abandon the operation
without changing anything.
2 - 27