Restore - DigiTech DigiGate-700 User Manual

DigiGate-700 for Windows
™
Figure 3-127
You must close the DigiGate-700 for Windows program before you make any attempt to
restore your data.
The DigiGate-700 for Windows program opens certain files while it is operating. These files cannot be
properly restored to the systems hard disk until they are closed. If you receive any error messages during a
restore process, close the restore operation, make certain the DigiGate-700 for Windows program is closed,
reboot the computer if necessary and then restart the restore procedure.
If you back up your files using another software package supplied with your backup device or a third party
software package, use that same software to restore the data to your system.
The following procedure applies to data that used Microsoft Backup and the procedures outlined in
Chapter 5 as the means of backup.
1. When you Click on the Restore button,
Figure 3-127, a Warning window is displayed
for the reason listed above.
NOTE: The DigiGate-700 for Windows
program uses Microsoft Backup. See "Chapter
5, Backing up your data" and your Windows
User Guide for a complete description of
Microsoft Backup.
DigiGate-700
for Windows
™
- User's Guide
®

Restore

®
Figure 3-128
2. Click on the Yes button to close the program,
or click on the No button to continue.
Figure 3-128.
NOTE: See "Chapter 5, "Backing up your
data" for a full explanation of the Restore
procedure.
3 - 61